Publicité
RADIO FREQUENCY (RF) ENERGY
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the United States and Industry Canada.
During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in
positions that simulate RF exposure in usage against the head with no separation, and near the body with the separation of 10 mm.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well
below the maximum value. This is because the device is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output.
The exposure standard for wireless devices employing a unit of measurement is known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg and 1.6 W/kg by Industry Canada.
This device is in compliance with SAR for general population /uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and Canada
RSS 102 and had been tested in accordance with the measurement methods and procedures specified in IEEE1528 and Canada
RSS 102. This device has been tested and meets the FCC and IC RF exposure guidelines when tested with the device directly
contacted to the body.
For this device, the highest reported SAR value for usage,
By the head is 0.62 W/Kg (1 g)
■
Worn on the body is 0.9 W/Kg (1 g)
■
Used as hotspot is 0.7 W/Kg (1g)
■
While there may be differences between the SAR levels of various devices and at various positions, they all meet the government
requirement.
SAR compliance for body-worn operation is based on a separation distance of 10 mm between the unit and the human body.
Carry this device at least 0 mm away from your body to ensure RF exposure level compliant or lower to the reported level. To sup-
port body-worn operation, choose the belt clips or holsters that do not contain metallic components to maintain a separation of 0
mm between this device and your body.
RF exposure compliance with anybody-worn accessory, which contains metal, was not tested and certified, and using such body-
worn accessory should be avoided
28
Publicité
