Publicité
(See Fig H2)
I1
3. Match the "-" symbol between the frame and the
slider, then lift the slider up to assemble the harness.
(See Fig I1)
NOTE: The harness is designed with three height
(S/M/L) for you to choose the suitable height.
I2
4.T
urn the toggle so that it lies 90
Pass the toggle and strap through the slot in the
frame. Release the toggle and pull back towards the
frame. Ensure that the shoulder strap is not twisted.
(See Fig. I2)
MAINTENANCE AND
CLEANING
Use soft brush to clean the debris on the surface of
harness. Never use water or chemical cleaners to
clean your harness. Wipe off any moisture with a soft
dry cloth as moisture can cause a shock hazard.
WARNING:Remove the battery and adaptor from
the harness before carrying out any adjustment,
servicing or maintenance.
STORAGE
Always store your harness in an enclosed space that
1
2
2
1
1
2
o
along the strap.
is inaccessible to children. Keep all working controls
free of dust. Keep away from corrosive agents. Do
not place any objects on top of the harness and put
the harness on the flat floor.
TROUBLE SHOOTING
The following table gives problems and actions that
you can perform if your machine does not operate
correctly.
WARNING: Switch the machine off
and remove the battery prior to any
troubleshooting.
Problem
Possible cause
The tool
1. Battery
fails to
not (properly)
operate
inserted
2. No electrical
contact between
the battery pack
and backpack
harness
3. The battery
pack is depleted
4. No electrical
contact between
the adaptor and
tool
There is a
Short circuit due
beep sound
to power cord
during
damage.
operation.
Solution
1. Properly
insert battery
into backpack
harness.
2. Remove the
battery pack
and check the
contact. Then
reinstall the
battery pack.
EN
3. Charge the
battery pack.
4. Disconnect
the adaptor
from the tool,
then reconnect
them.
Stop working
immediately.
Remove the
battery pack,
and replace the
power cord.
9
Publicité
