Publicité
Les langues disponibles
Les langues disponibles
EN
Step 3: Connect APsystems microinverters to the PV modules
When plugging in the DC cables, the microinverter should immediately
blink green ten times. This will happen as soon as the DC cables are
plugged in and will show that the microinverter is functioning correctly.
This entire check function will start and end within 10 seconds of plugging
in the unit, so pay careful attention to these lights when connecting the
DC cables.
NOTE: Each PV panel must be carefully connected to the same channel.
Make sure to not split positive and negative DC cables into two different
input channels: microinverter will become damaged and warranty will not
apply.
3
Publicité
