Teka RVU 10008 GBK Mode D'emploi page 30

 Internal light
In order to reduce energy consumption, this wine cabinet will automatically switch off the
LED lights after 10 minutes.
If you want the LED light to remain on continuously, this is possible. Please press and
hold the "LIGHT" button for 5 seconds, the display will show "LP".After 4 seconds the
display will revert back to normal and the light will remain on until manually switched off.
If you want to revert back and conserve energy (recommended), please press and hold
the "LIGHT" button for 5 second, the display will show "LF",after 4 seconds the display
will revert back to normal, and the light will automatically switch off after 10 minutes.
 Temperature Alarm
If the temperature inside is higher than 23 ℃, it will display "HI" on the display panel, and
after one hour after the alarm / buzzer will sound. This indicates that the temperature
inside is too high. If the temperature inside is lower than 0 ℃, it will display "LO" on the
display panel and at the same time the alarm also malfunction indicator is active.
 Temperature Recollection Function
In the event of a power interruption, wine chiller can remember the previous temperature
settings, and when the power is recovery, the cooler temperature will go back the same
setting temperature as power off.
Note

 If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine cooler will not
start.
 When you use the Wine cooler for the first time or restart the Wine cooler after having
been shut off for a long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED readout. This is normal and it
is due to the length of the activation time. Once the Wine cooler is running for a few
hours everything will be back to normal.
How to change the door opening

This appliance has reversible doors but is delivered with a right hinged door. The left hand
hinge kit comes with the unit (in the box), should you wish to reverse the hinge on your unit.
1. Lower hinge (Right)
4. Door
7. Top hinge (Left)
10. Door limit device
2 . Screws
5. Top hinge (Right)
8. Hole cover
11. Screw
28
3 .Door axis
6. Hinge Screws
9. Lower hinge (Left)