Perel TC90401 Mode D'emploi page 7

4. Overview
Refer to the illustrations on page 2 of this manual.
1
2
3
4
5
5. Assembly
1. Before using the ash cleaner, make sure all accessories are correctly fastened.
2. Unfasten the fixing clips and remove the cover from the ash collector.
3. Attach the filter to the lower part of the cover.
4. Replace the cover on the ash collector and fasten the fixing clips.
5. Attach the aluminium suction nozzle to the flexible hose.
6. Attach the flexible hose to the ash collector.
6. Operation
6.1 Vacuuming Ashes
Leave the ashes to completely cool down prior to vacuuming them!
1. Check if the device is assembled well before using it.
2. To vacuum ashes, connect the hose to the suction connection.
3. Insert the power plug into the mains socket.
4. Switch on the device.
5. Vacuum the cold ashes.
6. Switch off the device.
7. Unplug the device from the mains.
8. Remove the cover from the ash collector.
9. Throw away the ashes in an environmentally safe way.
6.2 Blow Function
Leave the ashes to completely cool down prior to blowing them!
1. Check if the device is assembled well before using it.
2. To use this blow function, connect the hose to the blowing connection.
3. Insert the power plug into the mains socket.
4. Switch on the device.
5. Switch off the device after use.
6. Unplug the device from the mains.
V. 03 – 02/07/2018
aluminium suction nozzle
cover
suction connection
hose
ash collector
TC90401
6
7
8
9
7
handle
blowing connection
on-off button
filter
©Velleman nv