Polar Refrigeration GH130 Mode D'emploi page 3

Telephone Helpline: 0845 146 2887 (United Kingdom)
Installation
Note: If the unit has not been stored or moved in an upright position, let it stand upright
for approximately 12 hours before operation. If in doubt allow to stand.
Remove the appliance from the packaging and the protective film from all surfaces.
1.
Avoid positioning the appliance in direct sunlight or damp areas.
2.
Insert the slide-out shelf/shelves at the desired levels and place the smaller shelf/shelves on the floor
3.
of the appliance.
If necessary, adjust the screw feet of the appliance to make it level.
4.
Note: Before using the appliance for the first time, clean the shelves and interior with
soapy water.
Operation
Control Panel
The control panel is located below the doors on the front of the
appliance.
Turn On
Close the door of the appliance.
1.
Connect the appliance to a mains power supply..
2.
Note: The Cooling Light is illuminated when the appliance is chilling the interior cabinet.
To Change the Operating Temperature
The default operating temperature is 2 °C. To display the operating temperature (set point), press and
immediately release the
To change the operating temperature;
Press and Hold the
1.
Press the or
2.
Press the button to store the temperature.
3.
Manual Defrost
POLAR Back Bar Chillers feature an automatic defrost. However, should the appliance require an additional
defrost period press and hold the
Automatic defrost cycles are every 6 hours and last 20 minutes (factory defaults).
Note: If a manual defrost is started this resets the automatic defrost timer. During
defrost periods the Defrost light is illuminated.
button.
button for 2 seconds, the "°C" will start to flash.
buttons to change the temperature.
button for 2 seconds.
Defrost Light Cooling Light
UK