Kenmore 461.99609 Guide Du Propriétaire page 8

Setting The Temperature Control;
The temperatureof the Wine Cooler Is controlled
by adJusUng/settthgthe thermoslat control knob,
located on Lheexterior rear wail of the cabinet.
To start the Wtne Coo!er and achieve maximum
cootlng quickly;
• Turn the temperature control knob clockwise
to the furthest 'Max' (maximum) setting on
the wider blue section of the graduated
control dial.
Allow the unit to run at thissetting for 3-4
hours.
• When maximum coolingis achieved, turn
back the temperaturecontrol knob setting to
the 10 o'clock posltfon on the graduated blue
controldial See fig.B.
To turnoff the Wine Cooler, (no cooithg)
rotate the control knob to the "O"(off)
position Sea rigA
C
Irk
Fig. A
Fig. B
Walt 3 to 5 minutes before restarting If opera-
tion has been Interrupted
Turn the control to the "O" (off) position to tem-
porarilydisconnectthe coolingcycle. When the
Wine Cooler ts not to be used for a long pedod of
time, disconnect the plug and leave the door par-
tiallyopen
Defrosting:
Your Wine Cooler Is designed with an "Auto-
Cycle" defrost system. What Is Auto Cycle
defrost?
The refrigerated surfaces defrost automatically
during the "off" cycle of the cold conltol. (thermo-
stat) Defrost water ts disposed of automatically,
by means of being channeled onto a drip tray
located on the compressor. Heat transfer from
the compressor causes the defrost water to
evaporate.
tf you move, remove or
securely fasten down all
loose Items inside the Wine
Cooler, To avoid damaglng
the leveling screws, turn
them aII the way Into the
base
Vacation Time
For short vacation periods,
leave the controI knobs at
their usual settings During
longer absences;
1, Remove alt bottles,
2. Disconnect from
electrical outlet.
3_ Clean the Wine
Cooler thoroughly.
4, Leave the door open
to avotd formallons of
condensate, mold or
odors.
7