Kenmore 461.99609 Guide Du Propriétaire page 7

REQUIRES; Phillips #2 Screwdriver.
1. Unplug the unit from the electrical outlet (if 6.
connected)and lay it on its beck,
2. Remov_ the screwsfrom thetower Hinge
Assembly, 7.
3, Pull the doordownward to remove it from the
cabinet of the Wine Cooler,
8.
4.
5_
Remove the upper hinge pin from the top
rightside of the cabinet and reinstall It on the
top left side°
Remove the plasticcap from the right side of
the door frame and reinstallit on the left side
of the door frame (the previouspin location),
Carefullyrepositlonthe door on the cabinet
and push up until the tophinge pin is
inserted into the top of the doon
While the door remainsclosed Install the
lower hinge assembly.
Close tha door and returnthe unitto its
uptight position(walt 60 minutes before re-
connecting power to the Wine Cooler),
verifythe door alignmentand proper seal
againstthe cabinet.
Upper Hinge Pin
i '°* I
,. S
Lower *hi'n_gA.;_mbly
and Door Support Bracket
Ensure all screws and fittings are tightly fastened
and that the door is squarely aligned with the cab-
inet before using. Adjust if nacessary,
6