Publicité
Les langues disponibles
Les langues disponibles
Q4:
After I successfully configured the Access Point to match my network
settings, I can not connect to my network using wireless computers.
A4:
If you have a DHCP server in your network, you need to go into TCP/IP
settings again and re-select "Obtain an IP address automatically" to allow the PC
to regain an IP address from your DHCP server.
Q5:
All the settings are correct, but I can not make a wireless connection to the
Access Point.
A5:
First, double check that the WLAN light on the Access Point is lit. Second,
power cycle the Access Point by unplugging the power to the Access Point. Wait
15 seconds, then plug the power back in. Third, contact the manufacturer of your
wireless network adapter. Make sure the wireless network adapter is configured
with the proper SSID. The default SSID of the Access Point is TRENDnet.
Q6:
The TEW-434APB does not power on when I plug the device into a Power-
Over-Ethernet switch or splitter. What should I do?
A6:
First, verify that the PoE device supports IEEE 802.3af protocol. Second,
verify that the TEW-434APB powers up using the provided 7.5V, 1A power
adapter. Third, power cycle the PoE switch. Fourth, unplug power to the switch,
wait 15 seconds, then plug the power back in. Fifth, plug the device into a
different port on the PoE switch. Sixth, try using another Cat-5e cable.
If you still encounter problems or have any questions regarding the TEW-434APB,
please contact TRENDnet's Technical Support Department.
9
Publicité
