Télécharger Imprimer la page

Toolland WEH300 Mode D'emploi page 11

Masquer les pouces Voir aussi pour WEH300:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
Intermittent Rating
This appliance is designed for
operation).
rated load for
minutes to
the total
Overload
The appliance is not
overload and overheating by a
If the permissible
temperature
switch
In case
the
cooling
In
case of direct exposure
significantly, which will also
possible that the temperature
will shut
8.
Care and Maintenance
Always disconnect the appliance from the mains before starting any cleaning, maintenance
or servicing work.
In the following: One cycle means one raising and lowering movement of a load. Periodic
inspection means an inspection after 100 cycles.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust.
Wipe the appliance with a clean cloth or blow it with compressed air at low pressure. Clean
the appliance regularly with a moist cloth and some soft soap. Do not use cleaning agents
or solvents as these could attack the plastic parts of the appliance. Ensure that no water
can seep into the appliance.
We recommend that you clean the appliance immediately after each use.
Maintenance
A check must be made every 30 cycles to find whether the entire steel cable is in good
condition. If it is damaged (split or bent, see illustration below), it must be replaced by a
steel cable of the type specified in the technical data.
Check that the power supply cable, motor stop switch and the push button are in good
working condition.
Servicing
Periodically test that the limit switches on the cable hoist are in correct working order.
Conduct this test as follows: when the cable has reached the maximum height, the lever on
the automatic stopping mechanism will be actuated. The motor must then stop (test
without a load).
V. 07 – 24/06/2021
WEH200/WEH300
operating type S3 20 % -
The relative duty
cycle
2.0
minutes during
cool off.
The appliance
operating cycle of
10 minutes
suitable
operating
time is
switch will shut
back
on after a
cooling
of a
strain on the appliance
time
will
decrease.
to
decrease the permissible
down. Please
wait
until the device is
10 min.
is
20 %, which
means that the appliance
each operating cycle and
can
therefore be
continuously
at
rated load.
for
continuous operation.
temperature
switch.
exceeded,
the motor temperature
the appliance off. The temperature
phase.
with a
lesser
load,
sunlight,
the temperature
switch will switch
off
after a short period and
cooled off.
WARNING
11
(periodic
intermittent
can
be
must then be
switched off
used for
a
duration
The motor is protected from
will
increase
switch
will
automatically
the operating time
will increase and
of
the
casing will
increase
operating
time. It is therefore
the appliance
operated at
for 8
of 20 % of
and
the
©Velleman nv

Publicité

loading

Ce manuel est également adapté pour:

Weh200