Publicité
Les langues disponibles
Les langues disponibles
8. Operation
a) Switching on and off
• To switch the device on, slide the on/off switch (2) forward.
• To switch the device off, slide the on/off switch (2) back to its original position.
b) Setting the vibration frequency
• Turn the vibration frequency controller (4) to set the vibration frequency:
The vibration frequency can be set between "1" and "6", where "1"
corresponds to the lowest vibration frequency (11000 min
to the highest vibration frequency (21000 min
9. Troubleshooting
The multi-purpose tool does not switch on:
• The battery is depleted. Charge the battery using the corresponding charger.
• The battery is not correctly inserted into the battery compartment on the back of the device.
The device vibrates vigorously and/or is very loud:
• The insertion tool is not attached properly to the tool holder (3). Check that the insertion tool is firmly seated.
Saw cuts are not clean / the edges of the cut are frayed.
• The saw blade is worn out or damaged and must be replaced.
• A saw blade that is unsuitable for the material or saw cut type was used.
• Protect sensitive materials (e.g. coated chipboard) with adhesive tape. The adhesive tape prevents fraying at the
cutting edge. A thin block of wood can also be cut at the same time to prevent fraying at the cutting edge.
Sawing performance is poor:
• The saw blade is worn out and must be replaced.
• The vibration frequency is not set correctly.
26
) and "6"
-1
).
-1
Publicité
