Publicité
Les langues disponibles
Les langues disponibles
Preparation
Open the unit and check carefully for visible damage.
Installation
The Fireplace should be located in an area:
• Out of direct sunlight
• Not susceptible to moisture
• Away from uninsulated outside wall
1. Place the assembled mantel near a 15-amp, 120-volt
grounded electric outlet. Read all instructions before using
this appliance.
2. Place the insert directly in front of the mantel opening.
3.
two foam rubber strips to prevent scratching of the hearth base. Slide the insert back through the opening
until the metal trim makes contact with the front of the mantel.
4. Install the mounting brackets provided with the insert in the pre-drilled holes on the bottom of the
insert (see Figure 2).
5.
6. Plug the power cord into the 15-amp, 120-volt outlet. Use an extension cord rated for a minimum of 1,875
watts if necessary.
CAUTION: MAKE SURE THAT THE UNIT IS INSTALLED SO THAT THE POWER CORD IS NOT
COMPRESSED AGAINST OR CAUGHT ON THE UNIT OR THE MANTEL AND THAT IT HAS AN
FIGURE 2
6
UNOBSTRUCTED PATH TO THE GROUNDED OUTLET.
Clearance to Combustibles
Sides
2-27/64 in. (61.5 mm)
Floor
0 in. (0 mm)
Top
2 in. (51 mm)
Front
36 in. (914 mm)
Rear
25/32 in. (20 mm)
Wooden Facing
[up to 5/8 in. (16 mm) thick]
ets
Mounting Brack
5/16 in. (8 mm)
Publicité
