Hisense AST-09UW4RYRCB04 Instructions D'utilisation Et D'installation page 20

Installation instructions
4. Connecting of the Cable
Indoor Unit
Connect the power cord to the indoor unit by connecting
the wires to the terminals on the control board individually
in accordance with the outdoor unit connection.
Note: For some models, it is necessary to remove the cabinet to
connect to the indoor unit terminal.
Outdoor Unit
1) Remove the access door from the unit by loosening
the screw. Connect the wires to the terminals on the
control board individually as follows.
2) Secure the power cord onto the control
board with cable clamp.
3) Reinstall the access door to the original position
with the screw.
4) Use a recognized circuit breaker for 24K model between
the power source and the unit. A disconnecting device to
adequately disconnect all supply lines must be fitted.
Caution:
1. Never fail to have an individual power circuit specifically for the air conditioner. As for the method of
wiring, refer to the circuit diagram posted on the inside of the access door .
2. Comfirm that the cable thickness is as specified in the power source specification.
3. Check the wires and make sure that they are all tightly fastened after cable connection.
4. Be sure to install an earth leakage circuit breaker in wet or moist areas.
Cable Specifications
Capacity (Btu/h)
7K~12K
7 K*~ 12
14K~18K
14K*~ 18
21K~30K
21K*~30K*
NOTE: K* means the
Attention:
The plug must be accessible even after the installation of the appliance in case there is a need to
disconnect it. If not possible, connect appliance to a double-pole switching device with contact
separation of at least 3 mm placed in an accessible position even after installation.
Power cord
Normal cross
Type
- sectional area
H07RN-F
1.0 /1.5
H05VV-F
K*
1.0/1.5mm X3
H07RN-F
1.5mm X3
K* H05VV-F
1.5/2.5mm X3
H07RN-F
2.5mm X3
H07RN-F
2.5mm X3
H05VV-F
2.5mm X3
power supply of this model comes from indoor unit.
2
Front panel
Indoor unit
Outdoor unit
The figures in this manual are based on the external
view of a standard model. Consequently, the shape
may differ from that of the air conditioner you have
selected.
Power connecting cord
Normal cross
Type
- sectional area
2
H07RN-F
mm X3 1.0 /1.5
2
H07RN-F
1.0/1.5mm X4
2
H07RN-F
1.5mm X5
2
H07RN-F
1.5mm X4
2
H07RN-F
0.75mm X4
2
H07RN-F
2.5mm X5
2
H07RN-F
2.5mm X4
13
Terminal (inside)
Cabinet
Chassis
Access door
Terminal(inside)
2
mm X5
2
2
2
2
2
2