Publicité
Les langues disponibles
Les langues disponibles
5. OPERATING INSTRUCTIONS
5.1 OVERVIEW
1 Mop casing
2 Hand strap
3 Telescope length adjuster
4 Handle
5 Hose attachment with locking valve
Figure 1: Overview
5.2 HOSE ATTACHMENT
First, set the locking valve to the ‚closed' position, Figure 2. Place your
hose on the hose attachment (Position 5 in the overview) of the mop.
When washing, set the locking valve to the ‚open' position.
closed
Figure 2: Locking valve
5.3 ADJUSTING THE LENGTH OF THE TELESCOPE
To adjust the length of the telescope, loosen the cap nut of the
telescope length adjuster (Position 3 in the overview). Pull the
telescopic rod out and refasten the cap nut, Figure 3.
loose
tight
Figure 3: Adjust length
open
5.4 USE WITHOUT TELESCOPIC ROD
To clean smaller surfaces, you can remove the telescopic rod from the
washing head. To do this, hold the washing head in one hand and
unscrew the telescopic rod with the other, Figure 4.
Figure 4: Remove telescopic rod
6. MAINTENANCE AND CARE
• After washing, rinse out any remaining cleaning products
completely.
• Open the locking valve and let the water run out. Any remaining
water can damage the mop in the event of frost.
• Let the microfibre mop dry out completely before putting it away
until needed again.
• Never leave the mop standing on the fringe/bristle end, hang it
up instead.
• The microfibre casing is washable.
7. NOTES REGARDING ENVIRONMENTAL PROTECTION
Dispose of the mop with telescopic rod in the bin or local collection
points.
8. CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
5
Publicité
