Trotec IDS 20 Manuel D'utilisation page 18

Problem
Operation indi-
cator
Fan starts running and c o n t i n u o u s
flame burns with smoke green light
formation
Device does not switch c o n t i n u o u s
off green light
B-8
Reset button Cause
Self-diagnostic
indicator
Solenoid valve defective
continuous orange Internal error of the elec-
light tronic control unit
- insufficient supply of com-
bustion air
Supply of combustion air
too high
used heating oil contami-
nated and/or containing
water
air has entered the heating
oil circuit
insufficient
quantity at the burner
too much heating oil at the
burner
Solenoid
-
defective
Operating manual – IDS 20 / 30
Error correction
Contact the customer service in order to:
- have the electrical connections checked.
- have the safety thermostat LI checked.
- have the solenoid valve cleaned or replaced.
Contact the customer service in order to:
- have the control unit reset; try to start-up the de-
vice at least twice. If the fault still occurs after-
wards, replace the control unit.
- Remove all obstacles or blockages from the intake
and/or exhaust openings.
- Have the position of the air setting ring checked by
the customer service.
- Have the support disc of the burner cleaned by the
customer service
- Have the position of the air setting ring checked by
the customer service.
- Replace used heating oil with clean heating oil.
- Clean the heating oil filter.
- Have the tightness of the lines and heating oil filter
checked by the customer service
heating oil Contact the customer service in order to:
- have the pump pressure value checked.
- have the nozzle cleaned or replaced.
Contact the customer service in order to:
- have the pump pressure value checked.
- have the nozzle replaced.
valve seal - Have the solenoid valve replaced by the customer
service.
EN