HUANUO HNCM2 Manuel D'instructions page 7

Step 4 Hang the Monitor or Laptop Tray on the Swivel Arm
4-1 Hang the monitor on the head of
swivel arm [05] as shown in the above
diagram.
HEAVY! You may need
assistance with this step.
Step 5 Adjustments
NOTE: If you do not intend to make tilt or swivel adjustment for different viewing
locations, you can tighten the bolts to prevent unwanted movement.
Tilt Adjustment
Tighten
Loosen
C1
Medium
Allen Key
The monitor should adjust easily when
moved, then stay in place. Adjust the tilt
tension bolt [T] if your monitor naturally
tilts up or down.
05
T
C5
4-2 Tighten the nut [I]. Make sure the
nut is secured before you rotate the
monitor.
NOTE: Please refer to the procedures 4-1
and 4-2 to install the laptop tray [09] with
VESA plate [08] on the head of swivel arm.
Swivel Adjustment
Loosen
The monitor should adjust easily when
moved, then stay in place. Adjust the
swivel tension bolts on the arms if your
monitor cannot stay where you set it.
07
M10
I
C1
Medium
Allen Key
Tighten