Hausmann 6135.468 Manuel De L'utilisateur page 24

OPERATION
When operating a portable power tool planer: always
be sure that the work piece is securely clamped to
your Clamping Table. This will avoid kickback which
could cause serious bodily injury.
To avoid injury, remove tools and parts from top
before adjusting Clamping Table height.
ADJUSTING HEIGHT
1. With one foot on step bar, slowly loosen one height adjustment locking
handle. Then slowly loosen the other handle. See Figure 3.
2. With table top resting on thigh, carefully lower or raise table top.
3. With table top still resting on thigh, reach down and secure one height
adjustment locking handle. Then secure the other locking handle.
SOLID SURFACE TABLE
Your HAUSSMANN Clamping Table can be used as a solid surface table
(Figure 4) and as a Clamping Table. To convert from solid surface to
clamping table simply remove the solid surface center board and adjust
table top jaws for desired application. Refer to Figures 4,5,6,7,8,9, and 10.
24
Fig. 3
Fig. 4