Télécharger Imprimer la page

Yaasa Desk Pro II Mode D'emploi page 25

Masquer les pouces Voir aussi pour Desk Pro II:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
Container and Shelfstopp
In the case that items of furniture (or other objects) are installed within the table's range of
movement, the range of movement can be limited to prevent collisions. Shelf stop positions
(preventing the table moving upwards) can be set in the upper half of the range of movement.
Container stop positions (preventing the table moving downwards) can be set in the lower
half.
1.
Move the table to the desired maximum or minimum height.
2.
Press and hold the „Save button" for about 10 seconds.
The table's range of movement will be limited to the saved position. To deactivate the
container or shelf stop position, repeat these steps.
Collision detection system (Intelligent System Protection = ISP)
Intelligent System Protection (ISP) is the collision detection system of the installed drive
system. It aims to reduce the risk of system damage. When an obstruction is in the table's
range of movement and the table collides with it, the load change is recognized by the table
system's components. If a load change is detected by the system, all drives stop immediately
and move for a short time in the opposite direction.
Factory Reset
To restore the Yaasa Desk Pro II to its factory settings:
1.
2.
3.
4.
5.
6.
Press the memory position keys 1,2 and the tabletop "UP" key
simultaneously. Hold this key combination for approximately 3 seconds
then release all the keys. The symbol S and a number, e.g. S 5, will be
visible on the display.
Press the tabletop "UP" key until S 0 appears on the display.
The symbol S 0 is now visible on the display.
Press the save key.
The control system has been reset to factory settings. A blinking 0 is
now visible on the display.
Perform a manual reset to enable the height adjustability.
EN
25

Publicité

loading