Yaasa Desk Pro II Mode D'emploi page 23

FAQs AND TROUBLESHOOTING
Complete troubleshooting instructions and FAQs are available on www.yaasa.com.
FUNCTIONS
Changing the table height
Press the arrow buttons on the handset in order to move the table upwards or downwards.
The desktop moves up or down until you release the key, or until the maximum or
minimum desk height is reached.
Duty cycle
The table may not be operated for more than 2 minutes continually. If this limit is exceeded,
an 18-minute rest phase is triggered. After this pause, the table can be used as normal again.
Excessive use of the table may cause permanent damage to the electronic components and
void the warranty.
Complete Retraction
When the table is 3 cm before the lowest position, it will stop automatically.
Pressing the "table down" button will prompt the table to move to its lowest position at a reduced
speed.
Saving a memory position
This function saves a set table height. Each memory position button can be used to save one
memory position. To save a tabletop position, proceed as follows:
EN
23