Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
3. When finished, shut off pressure washer. Relieve any pressure left in the line by pulling trigger on pressure
washer gun. Remove the foam cannon from the quick connect fitting.
4. Remove the sprayer from the bottle. Turn sprayer "counterclockwise" until you can remove it from the bottle.
5. Empty any remaining soap mixture.
CARE AND MAINTENANCE
1. To clean foam cannon, take the sprayer (without
the bottle) and hook it back up to pressure washer
gun or wand. Place intake tube into a bucket of
clean water. Turn on pressure washer and run
clean water through the sprayer.
2. When done, turn off pressure washer, disconnect
sprayer and dry.
TROUBLESHOOTING
PROBLEM
Connections leak.
Low soap output.
WARRANTY
TWO YEARS LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for two (2) years from
date of purchase. If within this period a product is found to be defective in material or workmanship, the
product must be returned with a copy of the bill of sale as proof of purchase to the manufacturer. This warranty
does not cover the product becoming defective due to misuse, accidental damage, improper handing and/or
installation and specifically excludes liability for direct, incidental or consequential damages. As some states do
not allow exclusions or limitations on how long an implied warranty lasts, the above exclusions and limitations
may not apply to you. This warranty gives you specific rights and you may also have other rights which vary
from state to state. For warranty service, call +1 (866) 870-9930, 9 a.m. - 5 p.m., EST, Monday - Friday.
POSSIBLE CAUSE
1. Inlet plug loose.
2. Bad coupler.
1. Too little soap added.
2. Filter is clogged.
1
CORRECTIVE ACTION
1. Retighten fittings.
2. Replace coupler.
1. Check manufactures recommended.
2. Try cleaning the filter.
3. Replace the filter.
2
Printed in China
www.surfacemaxx.com
Publicité
