GreenWorks PA321K Manuel De L'utilisateur page 8

EN
2. Remove the battery pack from the machine.
8.4 INSTALL THE DUST BAG
1. Remove the battery pack
2. Slide the dust bag into the dust exhaust port on the sander.
Empty and clean the dust box in good time.
8.5 INSTALL SANDPAPER
The cushion on the sander gives you the option of using
either non-adhesive sandpaper that clamps to the platen or
adhesive backed sandpaper with pressure sensitive adhesive
backing that sticks to the cushion.
1. Remove the battery pack.
2. Inspect sandpaper before installing; do not use if broken
or defective.
3. If replacing sandpaper, remove old sandpaper. To remove
paper, release paper clamp by lifting up on lever, and
disengaging it from the tab on the platen.
NOTE
English
4. Insert end of new 1/4 sheet sandpaper approximately 1/2
in. under the paper clamp.
5. Lift up on paper clamp lever and lock into place. Apply
downward pressure to conform sandpaper to platen.
6. Wrap sandpaper around cushion. Lift lever on opposite
end of sander and insert loose end of sandpaper under
paper clamp. Fit sandpaper against cushion tightly.
7. Lift up on lever and lock into place.
1/2 in. clamping of sandpaper is necessary for multi-sheet
stacking of paper.
8.6 PAPER PUNCH
A paper punch template has been supplied with the sander for
aligning and punching holes in sandpaper. The punched holes
must align with the holes in the sander cushion. Punching the
holes properly is a necessary step for dustless sanding.
1. Install sandpaper on the sander.
2. Align sander cushion to paper punch as shown.
3. Push down on sander.
8
NOTE