Publicité
Les langues disponibles
Les langues disponibles
EN
scratches left by the coarser grit and finer grit used for
finishing of the surface. Always continue sanding with
each grit until surface is uniform.
DO NOT use sander without sandpaper. Doing so will
damage the cushion.
10
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
11
GENERAL MANINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Clean the machine with a dry cloth. Do not use slovents.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Use only approved replacement parts.
12
REMOVING PRESSURE
SENSITIVE ADHESIVE (PSA)
SANDPAPER BEFORE
STORAGE
•
Do not store the sander with the sandpaper installed. Heat
generated from sanding causes the pressure sensitive
adhesive to flow and form a tight bond between the
backing pad and sandpaper.
•
Removing the sandpaper soon after you have finished a
sanding operation avoids letting the adhesive set up. If the
sandpaper is left on the backing pad for an extended
period of time after use, the adhesive will set up and
cause the sandpaper to become difficult to remove.
CAUTION
CAUTION
CAUTION
WARNING
WARNING
CAUTION
English
•
It may also tear when removing. When this situation
occurs, it becomes difficult to clean the backing pad for
the next sheet of sandpaper.
If you forget to remove the sandpaper after a sanding
operation, sand for a few minutes to soften the adhesive
backing before attempting to remove sandpaper.
12.1
CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
•
Clear the unwanted material out of the air vent with a
vacuum cleaner.
•
Do not spray the air vent or put the air vent in solvents.
•
Clean the housing and the plastic components with a
moist and soft cloth.
12.2
CLEAN THE DUST BOX
1. Remove the dust bag.
2. Empty the dust bag and clean the dust bag with a soft
brush.
For more efficient operation, empty the dust bag when it is
no more than half full. This will permit the air to flow
through the bag better.
13
TECHNICAL DATA
Voltage
No load speed
Orbit diameter
Size of paper
Weight (without battery)
Battery model
Charger model
14
LIMITED WARRANTY
10
CAUTION
CAUTION
NOTE
24 V
-1
11000 min
1.6 mm
1/4 sheet
2.3lbs (1.04kg)
LB24A020/BAG708 and
other BAG series
2978602/2903102 and other
CAG series
3
YEAR
ANS
AÑOS
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA
Publicité
