Publicité
Les langues disponibles
Les langues disponibles
4.Press the switch button to
select the desired mode.
5.Press and hold the switch
button to switch between
devices. Press the button
until you reach the desired
order position. Release the
switch button and select it
when the desired device is on
the screen.
6.Use + and - to adjust the
pressure value
7.Press the
power/start button to
inflate, and the
product will turn off
automatically after the
inflation is complete.
Tip 1: If the tire pressure value of the object to be inflated is higher
than the preset value, the product will It doesn't work.
Tip 2:BAR, PSI, KPA, KG/CM² , are units, not pressure levels.
12
Tip 3: Air compressors are not compatible with large capacity
objects. Such as air mattresses and air swimming pools.
Tip 4: Inflate the object only according to the recommended
pressure.
Lighting instruction
After starting up, press and switch successively.
Lighting -SOS- Warning flashing lights and side lights alternating red
and white-Lights off.
If the car cannot be started, please
check in order:
● The battery is low, you may need to charge the product more.
Please keep the battery charge above 60%, to ensure a successful
quick start.
● Rust or dirt on the battery terminals causes poor connection.
Clean the terminals and try again. It has activated its overheat
protection, please wait at least 1 minute to cool down and try again.
● The battery clamp is connected to the incorrect pole, please make
sure the clamp is connected to the correct terminal.
● There is a poor connection between the smart jump start clip and
the battery. Make sure the connection between the clip and battery is
secure.
13
Publicité
