Publicité
Les langues disponibles
Les langues disponibles
3.2.1. REMOVE THE TRANSPORT BOLTS
Warning!
■
You must remove the transport bolts from the backside
before using the product
■
You'll need the transport bolts again if you move the
product, so make sure you keep them in a safe place.
Please take the following steps to remove the bolts:
1.
Loosen 4 bolts with spanner and then remove them.
2.
Stop the holes with transport hole plugs.
3.
Keep the transport bolts properly for future use.
Warning!
■
You must remove the transport bolts from the backside
before using the product.
Loosen the 4 transport bolts
with a spanner.n
3.3. INSTALLING THE ACOUSTIC SPONGE
You may install the acoustic sponges, which can effectively reduce the noise caused
by the machine while it is working.
1.
Lay the machine on the floor as shown below, putting some soft material like
foam or clothes between the machine and floor as a protection.
2.
Stick the 2 longer sponges to the longer edges at the bottom of machine.
3.
Stick the 2 shorter sponges to the shorter edges at the bottom of machine.
2x
2x
Remove the bolts including the
rubber parts and keep them for
future use.
11
Close the holes using the
cover caps.
EN
Publicité
