Haier HRQ04WNAWW Guide De L'utilisateur page 10

HRQ04WNAWW 10/22/01 12:24 PM Page 19
9. Align the pin of the top hinge with top hole on the left
side of the door and push into place. Replace the screws in the
upper hinge bracket but do not tighten all the way,
10. Make sure the door closes easily but forms a tight seal.
Adjust the door as needed. Once you are satisfied with the door
alignment, completely tighten the upper door hinge screws,
1 1, Replace the hinge cover, insert the screw and
tighten completely. (see fig. # 2)
12. If the door does not close properly, refer to the
section titled "Door Alignment".
screw hole plug
door pin
lower hinge bracket
fig. # 3
9