F
Air fi lter cleaning
• Unscrew the air fi lter cover (A).
• Remove fi lter element and wash well in solvent.
• Replace the fi lter element and air fi lter cover (A).
• Be sure the fi lter cover seals properly all around.
TROUBLE SHOOTING
Motor hums but does not spray or irregular spray-
ing.
1. Worn swirl head
Replace swirl head.
2. Pick up pipe not into the right position
Re-adjust pick up pipe.
3. Blocked pick up pipe
Clean with thinner.
4. Blocked nozzle
Clean nozzle.
5. Blocked fi lter
Clean with thinner.
6. Control knob needs adjustment
Adjust.
Atomization is not good.
1. Volume adjustment is not correct.
Adjust
2. Paint too thick
Check viscosity of the paint
Over painting.
1. Spray gun not clean, or not lubricated, resulting in
piston being stuck in cylinder
Disassemble spray gun and dean with thinner.
2. Too much paint
Adjust the volume clockwise to reduce spraying.
Two t/i/n coats are better then one thick coat.
3. Viscosity too low
Check viscosity
Motor louderthan normal.
1. Spray gun not clean, or not lubricated, resulting in
piston being stuck in cylinder
Disassemble spray gun and clean with thinner.
No spray, no sound.
1. No electricity
Check power supply.
Operating sound not right.
1. Poor output adjustment
Re-adjust
2. Not enough paint in the container resulting in air
being sucked in.
Refi ll with paint
3. Not diluting properly or not passing pick up pipe
completely.
Check pick up pipe and viscosity level.
«Orange Skin» excessive fogging.
1. Incorrectsolventis used
Use correct solvent
2. Spray gun too far from the surface.
Hold spray gun closer to Vie object
3. Paint too thick
Thin the paint
MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor.
The SBM Group machines have been designed to oper-
ate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends
upon proper machine care and regular cleaning.
Cleaning
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots
free from dustand dirt.
If the dirt does not come off use a soft cloth moistened
with soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may dam-
age the plastic parts.
Faults
Should a fault occur, e.g. after wear of a part, please
contact your local SBM Group dealer. In the back of
this manual you fi nd an exploded view showing the
parts that can be ordered.
ENVIRONMENT
In order to prevent the machine tram damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations. Take
your unwanted machines to your local SBM Group-
dealer.
Here they will be disposed of in an environmentally
safe way.
GUARANTEE
The guarantee conditions can be found on the sepa-
rately enclosed guarantee card.
GB
9