Publicité
Les langues disponibles
Les langues disponibles
All operating elements and connections described
GB
can be found on the fold-out page 3.
1
Operating Elements and Connections
1.1 Transmitter
1 BNC plug for plugging onto the video output jack of
a camera
2 Transmitting antenna
3 12 V connection cable between camera and trans-
mitter
4 Microphone
5 Channel switches
6 Low voltage jacks (5.5/2.1 mm inside diameter/pin
diameter) for connection of a 12 V power supply unit
and for passing on the supply voltage to the cam-
era; pin = positive pole
1.2 Receiver
7 Plug-in power supply unit (8 V ) for the receiver
8 Antenna connection (SMA jack)
9 Button for manual channel selection
10 LEDs to indicate the channel received
11 DIP switches for the operating mode
Switches 1 – 4: The automatic channel selection will
switch between the channels of which the switches
8
are set to ON; the other channels will be skipped.
Switch M/L: To switch between manual channel
selection (M) and automatic channel selection (L)
12 Connection jack DC8V for the plug-in power supply
unit provided (7)
13 Jack A/V for the audio/video output
14 Reception antenna
2
Safety Notes
The units (transmitter, receiver, and plug-in power sup-
ply unit) correspond to all required directives of the EU
and are therefore marked with
WARNING The plug-in power supply unit is supplied
with hazardous mains voltage (230 V~).
Leave servicing to skilled personnel only.
Inexpert handling may cause an electric
shock hazard.
Please observe the following items in any case:
G
The transmitter must not be operated near cardiac
pacemakers (minimum distance 25 cm) and medical
appliances. The electromagnetic radiation may lead
to interference.
G
The units are suitable for indoor use only. Protect
them against high air humidity, dripping water and
splash water, and extreme temperatures (admissible
ambient temperature range -10 °C to +50 °C).
.
Publicité
