General Safety Warnings For The Tool; Electrical Safety - Ayce PLD2372 Manuel D'utilisation

2. Product symbols
In this manual and/or on the appliance the following symbols are used. These
represent important information about the product or instructions on its use.
2000 W
Rated Output
50 °C /50- 650 °C
temperature range
3 m cable

GENERAL SAFETY WARNINGS FOR THE TOOL

Failure to follow all the warnings and instructions may result in electric shock, re and/or
serious injury.
220-240V~/
SAVE ALL THE WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE.
50-60 Hz
The term "power tool" in the warnings refers to your mains operated (corded) power tool or
rated voltage
battery operated (cordless) power tool.
1 Work area safety
a) Keep work area clean and well lit.
250-500L/min air
ow rate Cluttered and dark areas invite accidents.
b) Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.

2 Electrical safety

a) Power tool plugs must match the outlet. Never modify the plug in any way. Do not
use any adapter plugs with earthed (grounded) power tools.
Unmodi ed plugs and matching outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces such as pipes, radiators,
ranges and refrigerators.There is an increased risk of electric shock if your body is earthed
or grounded.
c) Do not expose power tools to rain or wet conditions.Water entering a power tool will
increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the
power tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock.
e) When operating a power tool outdoors, use an extension cord suitable for outdoor
use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
f) If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
WARNING
Read all safety warnings and instructions.
| 72 GB
71