Publicité
1. Connect the gas cylinder to the barbecue following the instructions supplied
with the regulator.
2. Turn all the control knobs to the 'OFF' position.
3. Turn 'ON' the gas supply at the cylinder or regulator switch following the
regulator connection and operating instructions. Check the cylinder to
regulator connection and hose to barbecue hose inlet connection for leakage
by using soapy water. Any leakage will show as bubbles in the area of leak. If
leak is found, do not use the barbecue and turn off the gas supply. Consult
your gas or barbecue supplier for advice.
4.Before ignition, open the lid if there is. To light the left hand burner, push
down and turn the left burner control knob anticlockwise to the 90° position
(Full rate position) and then push down the igniter. An audible click will be
heard, this should light the burner. Check that the burner is alight. If the burner
has not lit, repeat this process.
5.If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5
minutes before retrying the ignition sequence.
6.When the burner has lit, the burner rate can be adjusted by turning the knob
anticlockwise to any position between the full and low rate positions.
- 29 -
Publicité
