Whirlpool WWC4589BLS Guide D'utilisation Et D'entretien page 5

Reverse Door Swing (optional)
1. Unplug the wine cooler and lay the unit on its back.
2. Unscrew the two Leveling Legs; one from the
bottom hinge on right and one from the left side of the
unit (see Fig. 3 and Fig. 4 for locations).
3.
Remove the bottom hinge by unscrewing its three (3)
screws ( Fig. 2 ).
NOTE: Keep this hinge in a safe place incase
you need to return to a right hand door swing.
4. Carefully remove the door and set aside by sliding
it downward off of the top hinge pin.
5. Remove the two (2) plastic screw caps located on top
of the hinge cover ( Fig. 1 ).
6.
Remove the top hinge cover by removing its two (2)
screws ( Fig. 1 ).
7.
Remove the top hinge by unscrewing its three (3)
screws ( Fig. 1 )
8. Remove the plastic door pin cap from the top left
side of the door and transfer it to the right side of the
door.
9.
Remove the three (3) Plastic Screw Caps from the
top left side of the cabinet and transfer them to the
top right side of the cabinet ( Fig.6 ).
10. Install the top hinge on the left side of the unit and
secure with three (3) screws. ( Fig. 1 )
11. Install the hinge cover back on the top hinge and
secure with two (2) screws. ( Fig. 1 )
12. Install the two (2) plastic screw caps on the hinge
cover. ( Fig. 1 )
13. Carefully install the door on the cabinet (insert upper
door into top hinge pin).
14. Using the left-side bottom hinge supplied with your
unit ( Fig.5 ): insert the hinge pin into the bottom of the
door, then align the holes in the hinge with the holes
in the cabinet and secure hinge to cabinet with three
(3)screws.
15. Install the Leveling Leg formerly attached to the
right bottom hinge ( Fig.4 ) onto the new left bottom
hinge, and install the Leveling Leg from the former
left side position into the right side position ( Fig.3 ).
16. Check door alignment, door seal and ensure the door
lock slides comfortably into the lock chamber. Tighten
all hinge screws.
Fig.5
Left Bottom
Hinge Assembly
IMPORTANT!
Allow the unit to stand upright for at-least 1 hour
before putting the unit into operation.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Fig.6
Plastic Screw Caps
Fig.3
Leveling Leg
Leveling Leg for Bottom Hinge
Fig.1
Top Hinge
Assembly
Fig. 2
Right Bottom
Hinge Assembly
Fig. 4
5