Publicité
Les langues disponibles
Les langues disponibles
Before washing for the first time
WARNING!
Hard water leaves a white coating on dishes and inside the dishwasher. It is therefore important
that you select the right setting for the water softener! See Water hardness.
Never run the dishwasher with an empty salt compartment if the water supply has a water hardness
in excess of 5°dH (9°fH / 6°eH / 0.9 mmol/l).
Basic settings
Open the door. Press
"First time setup." is shown on the display. It is important that you choose the right settings to ensure
good dishwashing results.
Select setting with
Settings
1.
Language
2.
Set level of rinse aid
0/1/2/3/4/5
Pre-selected at factory: 4
3.
Set water hardness
0/1/2/3/4/5/6/7/8/9
Pre-selected at factory: 4
4.
TAB On/Off
Pre-selected at factory: Off
To change the selected setting, see the chapter Settings.
8
.
. Confirm selected setting with
Select the language to be shown on the display.
Drying is faster and a better result is achieved if you use
rinse aid. You will also achieve a better dishwashing result
with clear and spotless dishes.
The rinse aid dispenser can be adjusted between 0 (Off)
and 5 (High dosage).
Adjusting the water softener. Select a setting depending on
the hardness of the water supply. It is important that this
setting is correct!
For a water supply with a hardness below 6°dH (10°fH /
7°eH / 1.0 mmol/l), select 0. The water softener is
deactivated and no salt needs to be added.
Activate this setting when using an all-in-one detergent that
contains rinse aid.
This setting reduces the rinse aid dosage and affects how
often the dishwasher's built-in softener is regenerated.
.
Publicité
