Publicité
Les langues disponibles
Les langues disponibles
Hardware installation
When the camera is switched on, it runs a self-test, and the Power/Activity LEDs flashes blue and red. If this
self-test completes successfully, the LED flashes blue and the Network camera is ready for you to enter an
IP address. After you enter an IP address, the blue LED flashes once every second. If the self-test is not
successful, the red LED flashes several times. For troubleshooting hints, see Appendix A.
The network camera will first detect Ethernet. If it does not connect to Ethernet, the network camera will try
WLAN. During the searching and connecting process to the wireless access point or station, the LED of the
network camera will keep red. Until the network camera is connected to the other wireless device, the LED
wil become blue and flash. Operating in either network mode, the blue LED will flash every second as
heartbeat to indicate alive.
Installation in Ethernet
Make sure the Ethernet is firmly connected to a switch. After attaching the Ethernet cable please plug in the
power adapter. If the LED turns off the be steady blue after self test, you can go to software installation. If the
Ethernet is not available, the network camera will switch to wireless LAN mode.
Installation in Wireless LAN
If the Ethernet is not available while power on, the network camera will search for any access point with
SSID "default". Once an access point is found, the LED will turn green to wait for installation. If the network
camera environment cannot meet the default settings, install the network camera in Ethernet to proceed with
wireless LAN configuration.
Consult your dealer for the correct installation of peripheral devices.
All manuals and user guides at all-guides.com
7
Make sure that all accessories and
articles listed above are present in the
scope
of
delivery.
Depending
application, an Ethernet cable may be
required. This Ethernet cable must meet
the specifications of UTP Category 5
(CAT 5) and must not be longer than 100
meters.
To prevent the risk of electric shock,
first
connect
the
socket
transformer to the security network
camera before inserting the transformer
into the mains socket.
on
of
the
Publicité
