Basic Accessories - IGM FMR3000 MultiRadius Mode D'emploi

FMR3000 operating instructions
DESCRIPTION
The jig is designed for cutting circles and ellipses at circumference or on the front side of the piece. It
extends the possibilities of the portable router and increases the quality of the machined surface as
well as the precision of the cut form. The basis of the whole jig system is the sliding cross frame made
of special plastic. Special sliders A + B are shifted within this cross frame.

BASIC ACCESSORIES

1 pc Cross frame made of special plastic
1 pc Connector plate
2 pc Control bolt M8
2 pc Sliders – complete
2 pc Guide rods D=10mm (upon request 8 mm ) L= 400mm
2 pc Distance rods with L =400mm screw
1 pc Distance rod L =400mm
1 pc Imbus Screw M8x20
2 pc Imbus Screw M5x16
2 pc Screw M4x25 with countersink head
1 pc Screw washer M8
2 pc Screw washer M5
1 pc Elastic screw washer M8
2 pc Wood screw 4x35
ASSEMBLY
(Fig. 7) Insert the guide rods D10 (6) into the grooves of the connector plate (3) and tighten with
screws M5x16 (12) and washers (11). Screw the control screw (7) into the sliders (2). Put the sliders
(2) into the cross frame (1). Assemble the distance rods D16 (5) and (4) together. Insert the end of the
distance rod with threading into the groove of the connector plate (3) and tighten with screw M8x20 (8)
and washer (9) and (10).
Put the sliders A and B into the guide grooves of the cross frame, insert the distance rod into the holes
in the pins of both sliders, tighten the control screws of the sliders. Assembly is now complete.
-EN 2-