Adjusting The Handle - UFLOOR WOLFF TURBO-STRIPPER 230 V/50 Hz Mode D'emploi

5.1 Starting
The Turbo-Stripper is equipped with a power-on indicator lamp
and an operating switch. The switch runs off at low-voltage
failures.
If the lamp does not indicate power-on, use another power
socket or check power supply.
If a mains power failure occurs during operation, switch-on the
machine again.
Preparations
Before starting work, cut the floor covering into strips of about
35 cm (12 inch). You cannot work faster if you cut wider strips.
To begin, cut one strip crosswise.
Then lift the floor slightly in order to get the blade underneath it.
We recommend to cut the first strip at right angles to the main
working direction. By so doing access to the adjacent strips is
made easier.
Cut the strips smaller if the floor covering is bonded very
securely, e.g. with an epoxy adhesive.
The blades are sharpened by the floor pavement. Therefore the
blade only has to be changed if it is twisted, collateral rounded
or becomes worn.
The driving wheels are subjected to wear. They have to be
changed after approximately 16 mm (0.6 inch) of the surface
has been worn away. Otherwise the working angle of the striking
apparatus will not be correct especially critical with cork or foam
backed carpets.
5.2 Assembly of support for additional weight (accessory)
Item no. 038535
The weight of the Turbo-Stripper is expandable by 1 up to 3
additional weights (1 single weight = 30 kg).
Individual weight shifting is possible at 3 positions (see picture)."

5.3 Adjusting the handle

The height of the handle can be adjusted to adapt the machine
to the stature of the operator. To adjust the inclination, loosen
the thumb screw at the foot of the handle.
After changing the hieght of the handle, it may be necessary to
readjust the handle attachment of the clutch.
TURBO-STRIPPER 230V, Artikel Nr. 038587 ab Masch. Nr. 0314/07
on off
blade`s width Messerbreite
If the machine is switched on, but the hand clutch is not
engaged, it might happen that the machine runs slowly
"backwards". This is caused by the return stroke of the
blade action. It means no failure of the Turbo-Stripper.
pos. ahead pos. center
without additional weight with 3 additional weights
2
1
01.05.07
1
6 5 4 3 2
pos. backward
13