Le Chai PRO1990MC Notice D'utilisation page 27

CHANGING DOOR OPENING SIDE
Due to the design, the door opening side cannot be changed.
REPLACING THE ILLUMINATING LAMP
The device uses light emitting diodes (LEDs). This type of diode cannot be changed by the user. The life
cycle of the LEDs is long enough so that they do not need to be changed. If however, in spite of the care
taken by the manufacturer, the LEDs do fail, please contact your Customer Care Service for any repair.
TROUBLESHOOTING
You can resolve many of the problems that may arise without having to call Customer Care Service.
Please try the suggestions below.
No operation
Not cold enough
No interior light
No display on the LCD screen
There appears to be a loud noise
The door does not close properly
The light (LED) does not come on
LED display error
The fans are not working
Imported by SIDEME SA – BP200 – F92306 Levallois Perret cedex
PROBLEM POSSIBLE CAUSE
 Check your installation's power supply
 Check your circuit breaker
 A fuse has blown
 Check the setting temperature
Ambient temperature requires readjustment
of the temperatures
 The door is open too often
 The door is not closed properly
 The door seal is not air-tight
 There is not enough space around the
device
 Contact your Customer Care Service
 Check the device levelling
 Verify that a piece of paper or part of the
packaging has not remained stuck in the
device.
 Check the device levelling
 The seal is in poor repair
 The feet have "moved"
 The control panel is not working
 Printed circuit problem
 Mains plug problem
 Contact your Customer Care Service
 Poor display
 The temperature value is not shown
 Contact your Customer Care Service
 Control Panel to be replaced by your
Customer Care Service
27