ZAZU Robby the rocker Mode D'emploi page 4

OPERATING THE PRODUCT
IMPORTANT
- Before using the product, make sure the product is firmly attached to the stroller or carseat.
- Regularly check for damage. Do not use when you see damage or signs of wear.
+
- Press the button to initiate the rocking motion. The red LED light above the
will illuminate, indicating that the rocker is in operation.
- The rocking will automatically stop after 40 minutes.
- Extend the horizontal bar as much as possible. The greater the distance from the wheelbase,
the more effective the rocking will be.
- Adjust the rocking frequency to achieve your desired gentle motion by using the
There are five different frequency settings available.
The rocker will remember the last used frequency for next time use
Note We recommend using the lowest effective rocking speed to maximize battery life.
- To manually turn off the product, press and hold the
CRY SENSOR
- The rocker also features an automatic activation mode triggered by crying/sound.
- To activate the cry sensor, press the red ZAZU button. The red LED light located above the ZAZU
button will illuminate, indicating that the cry sensor is in an active state.
- The cry sensor will remain active for 3 hours and will initiate rocking in response to sound.
- The rocking will continue for 10 minutes.
Note Please be aware that in noisy surroundings, the rocker may respond to other sounds
aside from crying.
DETACHING THE PRODUCT
1 Hold the product underneath with one hand to prevent dropping.
2 With the other hand, press the small black lever until you hear a click. The strap will release.
3 Now, pull the strap out of the clip and remove the product.
Note Ensure that the cry sensor is turned OFF to prevent the product from
activating on its own.
Make sure your baby is not underneath the rocker when detaching, in case it drops from
your hand.
+
-
button until the LED light switches off.
button
+
-
and buttons.
EN