ZAZU Robby the rocker Mode D'emploi page 3

POWER SUPPLY
Ensure the rechargeable battery is fully charged before initial use.
- When the battery indicator is blinking, it indicates that the product's batteries are running low,
and it's time to charge it.
- To begin, remove the product from the stroller.
- Next, open the charging lid and insert the charger plug.
- While charging, the indicator light will be red, and it will switch off once the batteries are
fully charged, taking about 2-2.5 hours.
- When you've finished charging, take out the charger plug and close the charger lid to prevent
water from entering.
Note For safety reasons, please note that the product won't operate while charging.
Use only the supplied cable to charge the product and insert it into a USCB power supply
with the following symbols.
This product is not compatible with fast chargers.
Please use a normal 5V charger with max 2.0 ampere or 10W.
BATTERY LIFE
- The battery life varies based on the rocking frequency. On average, a full battery can endure
approximately 15 cycles when operating at the highest frequency.
- Consequently, we recommend opting for the lowest effective rocking speed to maximize
the battery life.
POSITIONING THE PRODUCT
IMPORTANT
- The Rocker should be placed in a horizontal position. Avoid positioning it at an angle, as this will
reduce the effectiveness of the rocking and can reduce the lifespan of the motor.
- Ensure that the stroller or pram is on a level surface and that you have engaged the brakes before
using the product.
- Position the product so that the buckle faces your child, because the cry sensor is located on
that side. The buttons are aimed at the person standing behind the stroller.
- Never place the product directly above your child or within its reach.
- Please carefully read the safety instructions of the product you are attaching our rocker to.
- Never use the rocker on carseat or bassinet on an elevated surface.
ATTACHING THE PRODUCT
1 Grip the product securely with one hand, positioning it beneath the stroller's horizontal bar.
2 With your other hand, take hold of the strap and insert it into the buckle until it audibly clicks
into place.
3 Insert the strap as far as possible using your hand.
4 For a snug fit, employ the large black lever. Pull it upward to tighten by one additional notch.
Repeat this step until the product is securely attached.
Note If you do not tighten the product properly, it may result in a diminished rocking effect.
For safety reasons make sure the product is well tightened to the pushbar/handle.
EN