Amica WFG 3860 DB Notice D'utilisation page 36

Display
While adjusting the temperature, the display shows the set temperature.
The display will show the current temperature measured inside the appli-
ance after about 10 seconds.
Note: If the temperature sensor malfunctions, the display may show
"HH" or "LL" and you will hear a beep. Even if the temperature sensor
malfunctions, the appliance will continue to operate periodically in order
to maintain the correct temperature. Contact the manufacturer's service
department to repair the appliance as soon as possible.
Adjust temperature
• You can set the temperature individually for each zone in the range
from 5-12°C (Upper zone) and 12-20°C (lower zone) and 5-20°C
(single zone).
• If active, disable the Child Lock, then touch
or lower).
• Touch or
Note: When you connect the appliance to power for the first time, or
after it was not used for an extended period, it may take longer to reach
the set temperature.
Change the temperature unit
Touch and hold two sensors
°F.
Note: Blinking of the temperature unit means the compressor is operat-
ing. This is normal device operation.
to set the desired temperature.
for 5 seconds to switch between °C and
- 36 -
to select zone (upper