CONTROLS
Controls - one and two zones
The control panel is shown in Figure 4. It is also shown below:
Single zone
Dual zone
– Power on/off
– Lighting
– "+"
– "–"
- Temperature unit changing
- Zone changing
Power on/off
After connecting the appliance to the power supply, touch and hold
10 seconds for one of the zones to turn appliance on. Each zone has a
separate control panel. Regardless of the lock control panels, touch and
hold
for 10 seconds.
When you turn off any zone, wait at least 5 minutes before turning it
back on. Turning it on early may damage the compressor.
Child Lock
To enable or disable the Child Lock, touch and hold two sensors
3 seconds. You will hear a beep. Child lock automatically switch on after
5 seconds after touching the panel.
Interior lighting
If active, disable the Child Lock and then touch
off. The effect will be visible after closing the door. The light is always on
when you open the door.
- 35 -
to turn the light on /
for
for