Bimar FD-40M Notice D'instructions page 9

must be kept out the reach of children because they are potential sources of danger. Note: any stickers
or advertising material applied to the grille must be removed before using the appliance.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of your
electricity, and that the electric plug is grounded. In the event of incompatibility between the plug
point and the plug of the appliance, have the plug replaced with q suitable one by professionally
qualified personnel, who will make sure that the section of the wires of the outlet is suitable for the
power drawn by the appliance. In general, the use of adapters or extension cords is not recommended;
if their use is necessary, they must conform to existing safety standards and their current capacity
(amperes) must not be less than the maximum of the appliance.
• Before each use, check that the equipment is in good condition, that the power cord is not damaged: if
in doubt consult a qualified professional.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Keep the appliance away from:
- heat sources (e.g. open flame, gas stove, etc.)
- liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it falling in
(minimum distance of 2 meters)
- fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille; make sure
that the front is free of floating materials (dust, etc.).
• The appliance must not be used in dusty environments or in the presence of floating materials or used
in a room where there is a fire risk.
• Stand the appliance on a smooth, horizontal surface or table; do not place it on a inclined surface (the
appliance could fall over).
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete with its
base and support and protection grid.
If in doubt, have the appliance checked or assembled by a qualified professional person. For assembly,
refer to figure.
Attention: always unplug the appliance before you assemble.
1) Insert rod (4) into the base (3) and counterweight (2), inserting it into its seat, and lock it with the "L"
screw and washer (1).
2) Extend the adjustable rod (6) to the desired height and secure by tightening the fixing rod fastening
screw (5).
3) Place the motor housing (11) on the adjustable column
1) "L" screws
2) Counterweight
3) Base
4) Fixed rod
5) Rod fastening screw
6) Adjustable rod
7) Safety screws
8) Nut with retaining screw grip
9) Cord
10) Clutch screw (up / down)
11) Motor housing
12) Oscillation button
13) Switch
14) Screw with nut
15) Front grill/protective screen
16) Fan
17) Fan fixing screw
18) Rear grill fixing screws
19) Rear grill
20) Motor shaft
21) Round-head retaining screw
9/27