Publicité
Les langues disponibles
Les langues disponibles
English
Fig. E
7
Proper Hand Position (Fig. F)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
. one hand on the battery
10
Fig. F
Trigger Switch and Forward/Reverse
Button (Fig. G)
•
The drill is turned ON and OFF by pulling and releasing
the trigger switch
1
. The farther the trigger is
depressed, the higher the speed of the drill.
•
A forward/reverse control button
rotational direction of the tool and also serves as a lock
off button.
•
To select forward rotation, release the trigger switch and
depress the forward/reverse control button on the right
side of the tool.
•
To select reverse, depress the forward/reverse control
button on the left side of the tool.
•
The center position of the control button locks the tool
in the off position. When changing the position of the
control button, be sure the trigger is released.
8
6
Adjusting Torque Control (Fig. A)
This tool is fitted with a torque adjustment collar
the operating mode and to set the torque for tightening
screws. Large screws and hard workpiece materials
require a higher torque setting than small screws and soft
workpiece materials.
.
6
•
•
10
6
Speed Selector (Fig. H)
The speed selector feature of your drill allows you to shift
gears for greater versatility.
•
•
2
determines the
nOTE: Do not change gears when tool is running. If you are
having trouble changing gears, make sure that the speed
selector is either completely pushed forward or completely
pushed back.
Fig. G
1
For drilling in wood, metal and plastics, set the collar to
the drilling position symbol
For screwdriving, set the collar to the desired setting. If
you do not yet know the appropriate setting, proceed
as follows:
-
Set the collar to the lowest torque setting.
-
Tighten the first screw.
-
If the clutch ratchets before the desired result
is achieved, increase the collar setting and
continue tightening the screw. Repeat until you
reach the correct setting. Use this setting for the
remaining screws.
To select low speed, high torque setting (position 1),
turn tool off and permit to stop. Slide speed selector
away from the chuck.
To select the high speed, low torque setting (position 2),
turn tool off and permit to stop. Slide speed selector
back toward the chuck.
2
3
to select
.
4
Publicité
