Publicité
Les langues disponibles
Les langues disponibles
2. Layout (B1)
1. Handle
2. ON/OFF switch
3. Additional handle
4. Lock of chuck
5. Tool chuck
6. Oil filler opening
7. Allen key
3. Proper use
This machine is designed for heavy duty
demolition and chiseling work using the
appropriate chisel.
The equipment is to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user / operator and not
the manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the machine is used in commercial,
trade or industrial businesses or for equivalent
purposes.
4. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
4.1 Additional handle (B2,B3)
For safety reasons you must only use the
demolition hammer with the additional
30
handle.
The additional handle (3) enables you to achieve
better stability whilst using the demolition
hammer.
For safety reasons the machine must not be used
without the additional handle (3).
The additional handle can be turned into any
required position. Undo the lock of the additional
handle (3). Then turn the handle into the most
comfortable working position and tighten the
screws again.
4.2 Inserting the tool (B4,B5)
• Clean the tool before fitting it and apply a thin
coating of grease to the tool shaft.
• Pull back the SDS MAX chuck lock (4) as far as
possible. Insert the chisel as far as possible and
turn it until it locks.
• Release the SDS MAX chuck lock. It should only
be possible to move the chisel in the drill chuck
by approximately 1 cm forwards or backwards.
• Check the lock by pulling the tool.
4.3 Removing the tool
To remove the tool, proceed in reverse order.
5. Starting up
Important.
To avoid danger, the machine must only be
held using the two handles (1/3). Otherwise
you may suffer an electric shock if you chisel into
cables.
5.1 Switching on and off (B6)
To switch on:
Press the control switch (2).
To switch off:
Release the control switch (2).
Publicité
