Philips DL8780 Mode D'emploi page 9

Compliance with standards
Using the body analysis scale
Preparing for use
Inserting/removing the batteries
This Philips device complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
This Philips body analysis scale automatically switches on as soon as you
step on the measurement platform. The device applies BIA (bioelectrical
impedance analysis) technology. Weak current flows through the human
body so as to measure the bioelectrical impedance and estimate body fat
percentage. The electrical current is small and may not be felt. This BIA
technology is non-invasive and toxic-free. The electrical current mentioned
above is less than 1mA.
Insert new batteries (4x 1.5V AAA) before the first use.
Replace weak batteries before they discharge completely.
Note: Data will be lost when the battery is completely empty.
If you do not intend to use the device for a long period of time, it is advised
to remove the batteries before storing.
Caution: Replace all four batteries at the same time. Do not mix the old
batteries with the new ones.
This device has a battery low indication. When the battery level is below
operating value, this will be indicated by the low battery icon after which the
device shall switch off within 4 sec.
1 Open the battery compartment at the back of the device.
2 Insert the batteries (4x 1.5V AAA) into the battery compartment according
to the polarity indications marked inside the compartment.
English
9