Candy CSO 496TWMB6/1-S Mode D'emploi page 69

PAUSING THE MACHINE
 While a cycle is running, the machine can
be paused by simply pressing the
PLAY/PAUSE button.
For safety reasons, in some wash
cycle phases, the door can be opened
only if the level of the water is below
its lower edge and if the temperature
is less than 45°C. If these conditions
are met, wait for the DOOR LOCKED
light to switch off before opening the
door.
Press the PLAY/PAUSE button again to

resume the programme from the cycle
phase where it left off.
CANCELLING THE SET PROGRAMME
To cancel the programme, set the

selector to the OFF position.
Wait until the DOOR LOCKED light has

gone out before opening the door.
TEMPERATURE SELECTION
button
This button allows you to change the

temperature of the wash cycles.
It is not possible to raise the temperature

over the maximum allowed for the
programme, in order to protect the
fabrics.
If you want carry out a cold wash all the

indicators must be off.
SPIN SPEED button
By pressing this button, it is possible to

reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
If the label does not indicate specific

information, it is possible to use the
maximum spin expected in the program.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
To reactivate the spin cycle press the

button until you reach the spin speed you
would like to set.
It is possible to modify the spin speed

without pausing the machine.
An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
EASY IRON button
(Available on some programmes only)
This function allows you to minimize
creases as much as possible, eliminating
the intermediate spins or reducing the
intensity of the last one.
This option must be selected before
pressing the PLAY/PAUSE button.
If the option is not compatible with the
selected programme then the option
indicator light first flashes and then
goes off.
DELAY START button
This button allows you to pre-programme

the wash cycle to delay the start of the
cycle for up to 24 hours.
69
foaming. If the
the load be