Publicité
Les langues disponibles
Les langues disponibles
•
Attach rotary ignitor to control panel using two #8x1/2" self-tap screws (A).
3
•
Attach round end of ignitor wire to rotary ignitor (A).
•
Attach valve to control panel
•
Make sure valve is inside burner tube. Secure control panel using one #10x3/8" self-tap screw through single
tab side (B).
•
Slide heat shield between
screws assuring heat shield is attached using bottom screw (C).
•
Attach spade end of wire to electrode (D).
A
#8x1/2"
Self-Tap Screw
Valve angles
to side
Hose angles
downward
C
View is shown
with unit upside-down
Ignitor
wire
14
All manuals and user guides at all-guides.com
holding valve in correct position using two #6-32x3/8" threaded screws (A).
appliance body and louver side of
#6-32x3/8"
Threaded Screw
Control Panel
Louver Side
Ignitor
Valve, Hose,
Regulator Assembly
Ignitor Wire
Heat Shield slides
between Control Panel
and body and underneath
Ignitor Wire.
Heat shield hole
aligned with
Bottom screw
#10x3/8"
Self-Tap Screws
control panel. Secure with two #10x3/8" self-tap
Qty: 3
#10x3/8"
Self-Tap Screw
B
View is shown
with unit upside-down
Burner Tube
#10x3/8"
Self-Tap Screw
Carefully insert valve end into
burner tube making sure valve
is centered with burner tube,
After aligned correctly, secure
with one self-tap screw on single
tab of control panel.
D
Electrode
Qty: 2
Qty: 2
#6-32x3/8"
#8x1/2"
Threaded Screw
Self-Tap Screw
Valve and Burner
Centered
Valve end
Spade end
of ignitor wire
View is shown
with unit upside-down
Publicité
