NAIPO oPillow Plus Guide D'utilisation page 5

MASSAGE AREAS
WAIST
ABDOMEN
IN THE BOX
Massager
06
BACK
LEG (CALF)
Wall Adapter
OPERATION GUIDE
How to use
Position the product on desired place.
Hold down the power button for 2 seconds to start the product. The heating
and rollers will automatically switch on. The default timer is 15 minutes.
Press the heating button to turn off the heating function; (when the heating
function is on, the indicator light is green).
Press the speed adjustment button to choose the desired massage speed
level: Low / Medium / High.
Press the power button to stop the massage at any time.
SPEED HEATING
LOW / MEDIUM / HIGH ON / OFF
ON: GREEN
OFF: LIGHT OFF
Charging
The indicator will light up in red when the product is low on battery. When the
battery is low, plug in and charge.
Insert the cylindrical end of the charger cable into the product charging port,
and plug the adaptor into an electrical power outlet.
A full charge cycle takes approximately 4 hours. During charging, the
indicator ashes red and it turns to green when the product is fully charged.
When connected to a power supply, the product will automatically charge if
the battery is low.
The product can be used continuously for 60 minutes in a fully-charged
condition.
NOTE: The product can be used while plugged into a power source but the product
will not charge.
CLEANING AND STORAGE
To prevent damage and discoloration, do not clean the
product with corrosive detergent. Do not write on, or poke
the product with sharp pen tips.
Before cleaning, make sure that the product has been turned
off and that the adapter has been pulled out from the outlet.
Clean with a dry cloth.
POWER
ON / OFF
IN USE: GREEN
LOW POWER: RED
EN
07