TEFAL WINDOW KO472831 Mode D'emploi page 8

- Do not use scourers to clean the kettle.
- To remove the scale filter, remove the kettle from its base and leave it to cool down. Do not remove the filter when
the appliance is filled with hot water.
- Do not use any method to descale the kettle other than that recommended.
- Do not fill the kettle above the maximum water level, or use it if it is below the minimum level. If the kettle is
over-filled, water may splash out of it.
1 Remove all of the various packaging, stickers or accessories from both the inside and outside of the kettle.
2 Adjust the length of the cord by winding it under the base. Wedge the cord into the notch. (fig 1)
Throw away the water from the first two/three uses as it may contain dust. Rinse the kettle and the filter separately.
Use
1 TO OPEN THE LID, ACCORDING TO THE MODEL
- Hinged lid: press if necessary on the locking system and pull backwards. (fig 2)
- Assisted opening lid: press on the locking system and the lid lifts automatically (fig 3)
- Automatic opening lid: press the button at the top of the handle. (fig 4)
- Lockable lid: turn the lid to the left to unlock it and lift it. (fig 5)
To close the lid, press it down firmly or turn it to the right in the case of the lockable lid.
2 PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY FROM WATER
SPLASHES AND ANY SOURCES OF HEAT.
Your kettle must only be used with the base that matches it and its own anti-scale filter.
3 FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (FIG 6)
You can fill it through the spout, which ensures better maintenance of the filter.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the kettle is too full, boiling water may spill
out.
• Do not use without water.
• Check that the lid is closed properly before use.
• The kettle must always be used with its own anti-scale filter.
4 POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS SOCKET.
5 FOR KETTLES THAT FEATURE A TEMPERATURE SWITCH, SELECT THE TEMPERATURE
ACCORDING TO YOUR NEEDS
Position for boiling water or position
kettle above the maximum water level, or use it if it is below the minimum level. If the kettle is
over-filled, water may splash out of it.
6 TO START THE KETTLE
Press the on/off button positioned on the top or the bottom of the handle according to the model. (fig 8)
7 FOR KETTLES THAT FEATURE A TEMPERATURE SWITCH
if you move quickly from position
that this is taking a long time, you can add cold water to speed up the start of heating.
8 THE KETTLE MAY HAVE AN INTERNAL LIGHT, DEPENDING ON MODEL
Before using for the first time
for the ideal temperature for drinking immediately. (fig 7)Do not fill the
to position after heating the water, the kettle has to reinitialise. If you think
6