Publicité
Les langues disponibles
Les langues disponibles
EN
SAFETY INSTRUCTIONS
•
Check the product, power cord, plug and
all accessories for any damage. Do not
use the product if any parts are missing or
damaged. Contact the retailer.
•
Do not start the product before it is fully
installed according to the instructions.
•
The product is only intended for extra
heating in the home.
•
The product has an IP24 protection rating
and can be used in bathrooms or laundry
rooms. Do not place the product less than
1.5 m away from sources of water
(bathtub, wash basin, toilet). Make sure
that the product cannot drop into water,
and that water cannot get into the
product. Pull out the plug immediately if
the product comes into contact with water
or any other liquid.
•
Do not use the product if the power cord
or plug are damaged, if the product has
been in contact with water, is not working
properly, or if it is damaged in any other
way.
•
Take the product to an authorised service
centre to be checked, repaired or
adjusted.
•
Never immerse the power cord or the plug
in water or any other liquid – risk of
electric shock. Do not touch the product,
the power cord or plug with wet hands.
•
Check that the mains voltage corresponds
to the rated voltage on the type plate. The
product must be connected to an earthed
power point with a residual current device
that has a maximum tripping current of
30 mA.
•
Fully unwind the power cord before use.
Do not allow the power cord to come into
contact with any part of the heater and
keep it away from other sources of heat.
Do not lay the power cord under carpets
or where it can be trod on. Make sure that
there is no risk of tripping over it, or it
being damaged or put under strain. Do
not lay the power cord round a corner, or
fold or wind too tightly when the product
is not in use.
•
Do not use an extension cord unless it is
necessary – fire risk. An extension cord
20
must be in good condition and of an
approved type, with a minimum
cross-sectional area of 3 x 1.5 mm².
•
Connect the product to a separate power
circuit.
•
Do not use the product outdoors or in
areas with a floor area of less than 10 m².
•
Switch off the product before pulling out
the plug. Never switch off the product by
pulling out the plug.
•
Do not use the product in an explosive
environment,
e.g. near flammable liquids, gas or dust.
•
Do not place the product near or directly
below a power outlet, or near a fire or
other source of heat.
•
Do not use the product near animals or
place it near furniture, paper, curtains or
other flammable materials – fire risk. Do
not place the product closer than 1 metre
to any flammable material.
•
Never cover the product – fire risk. Keep
the ventilation openings on the product
clean to prevent overheating and the risk
of fire. Do not put anything on the
product or attempt to dry clothes on it.
•
Make sure that air can circulate freely
around the product. Do not place the
product near walls or large objects, under
furniture or in a cupboard, where there is
poor circulation of air.
The necessary free space for the exchange
of air round the product is specified in
the section on installation.
•
Never insert foreign objects into the
ventilation or outlet openings – risk of
electric shock, fire and/or material
damage.
•
The product can be controlled manually or
by remote control with a timer or app.
Always follow the safety instructions,
irrespective of how it is controlled.
•
Switch off the product before pulling out
the plug. Pull out the plug when the
product is not in use. Do not pull the
power cord to pull out the plug.
•
Switch off the product, pull out the plug,
and wait until all parts have completely
cooled before handling, moving, cleaning
and/or maintenance.
Publicité
