Publicité
Les langues disponibles
Les langues disponibles
Filling The Rinse Aid Reservoir
Remove the rinse reservoir
1
cap by lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the
dishwasher is designed to adjust the consumption by user. Follow the
below steps.
1. Open the door, switch on the appliance.
2. Within 60 seconds after step 1, press the Program button more
than 5 seconds, and then press the Delay button to enter the set
model, the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to
your using habits , the sets will change in the following sequence:
D1->D2->D3->D4->D5->D1. The higher the number, the more rinse
aid the dishwasher uses. The factory setting is D3.
4. Without operation in 5 seconds or press the power button to exit
the set model, the set success.
Pour the rinse aid into the
2
dispenser, being careful
not to overfill.
41
V.3
Publicité
