Scubapro Nova 850TEC Mode D'emploi page 3

INSTRUCTIONS
To turn ON the SCUBAPRO NOVA 850TEC turn
the light head counter clock-wise and the light
body clock-wise until it is finger-tight and the
light turns on. Make sure to not over tighten the
casing as this could result in premature wear and/
or damage to the O-rings.
*NEVER USE A TOOL OF ANY KIND TO
TIGHTEN THE CASE*
To turn OFF the NOVA 850TEC slowly turn the
light head clock-wise until the light turns off.
Once the light is off, do not turn the casing any
further.
If the casing is unscrewed too far, flooding may
result.
! WARNING
Do not look directly into the light, or direct
the light into the eyes of others. Do not
alter or modify the dive light. If modification
causes water entry or other malfunctions,
the warranty will be void.
The light is fitted with an overpressure
valve for your safety. In case the battery
produces gas leading to a high internal
pressure of the light, the valve will open.
This could cause water to enter the light.
Proper storage: if the dive light is not to be
used for a long period of time, remove batteries
to avoid accidental leakage.
Proper maintenance: frequent use of the dive
light may cause O-rings to dry out. To avoid
leakage, clean O-ring groove with a cotton
swab and regularly apply lubricant to O-rings
to help prevent dry cracking. Please rinse the
NOVA 850TEC with fresh water before storing.
3